Przedsiębiorstwo Badawczo-Produkcyjne OPTEL Spółka z o.o.
 ul. Morelowskiego 30 PL-52-429 Wrocław
 phone: +48 71 329 68 53 fax: +48 71 329 68 52 NIP: 898-10-47-033
 Research & Development / Ultrasonic Technology / Fingerprint recognition

    

Generator UG-1002M
rev. 1.0/0.7N

UG-1002M Generator is designed for use with high-power ultrasonic transducers commonly used in washers and equipment for welding and cutting of materials, chemical reactors, etc. The specific properties of these transducers cause that each generator is matched to a particular transmitter ie its frequency and input impedance characteristics. The generator can be controlled manually - from the front panel or remotely - via DB15 connector located on the rear panel.

Standard equipment:

- Generator Module UG-1002M
- The power cable
- Cable to connect the ultrasound transducer




Technical data:

Operating frequency:
Automatically adjust range:
Minimum output voltage:
Maximum output voltage:
Power output:
Therange of permissible load impedance:
Supply voltage:
Fuse, time delay:

dimensions [mm]:
Weight:


34 600 Hz
34 000 - 35 000Hz
< 200Vpp
1500Vpp
1000W*
100 - 500Ω
230VAC
10A

233x121x370
8kg

*- *-Measured at 250Ω capacitive impedance (ca. -30°)


Copyright © 1989 - 2013 Optel. All rights reserved.
Limited, registered in the Companies Register by the regional court Wroclaw Fabryczna, VI Industrial Section of KRS, under the number 0000124439,
NIP: PL 8981047033, REGON 008375538, operating capital 364,500 PLN